今天是2020年9月7日 星期一,歡迎光臨本站 合肥環瑞機械設備制造有限公司 網址: www.cnhuanrui.com

公司動態

雕刻機的日常保養

文字:[大][中][小] 2016-7-13    瀏覽次數:1692    
雕刻機的日常保養

連續運行時間每天10小時以下,保證冷卻水的清潔及水泵的正常工作,絕不可使水主軸電機出現缺水現象,定時更換冷卻水,以防止水溫過高。冬季如果工作環境溫度太低可把水箱里面的水換成防凍液。

每次機器使用完畢,要注意清理,務必將平臺及傳動系統上的粉塵清理干凈,定期(每周)對傳動系統(X、Y、Z三軸)潤滑加油。X、Y、Z三軸光桿用機油進行保養;絲桿部分加高速黃油;冬季如果工作環境溫度太低,絲桿、光桿(方形導軌或圓形導軌)部分應先用汽油進行沖洗清潔,然后加入機油,否則會造成機器傳動部分阻力過大而導致機器錯位。

對電器進行保養檢查時,一定要切斷電源,待監視器無顯示及主回路電源指示燈熄滅后,方可進行。雕刻機使用三個月左右要對緊固件進行檢查,龍門兩側的連接螺絲、絲杠螺母的緊固螺絲、兩側電機的緊固螺絲進行緊固。


How to Maintain Engraving Machine

The working time of the engraving machine should be controled within 10 hours a day; keep the cooling water clean and maintain the operation of the pump; never let the water dry in the spindle, exchange the cooling water regularly to prevent the high temperature of the water; in winter, if the operating ambient temperature is too low, you can use antifreeze to instead of the water in the tank.

After using of the machine, pay attention to clean up, make sure to clean up the dust on platform and transmission system, to lubricate and refuel the transmisson (X,Y,Z axis) system regularly(weekly); use the engine oil to maitain the X,Y,Z axis; add high-speed butter at screw part; if the working temperature is too low in winter, the screw and polished rod (square rail or round rail) part should be rinsed with gasoline, then add engine oil, otherwise the high resistance of the transmission parts will make the CNC router dislocation.

When you do the electrical maintenance checking, make sure to cut off power supply. after the monitor has no display and the main circuit power indicator light turns off, it can be carried out. after using the machine around three month, you should check the fastener, and tighten the screws of both sides of the gantry, the screw nut and both sides of the motor.




返回上一步
打印此頁
[向上]

網站首頁

產品中心

公司介紹

資訊動態

聯系我們

在線詢單

免费国产久久啪久久爱